|
|
|
Art of Making Whiskey by Anthony Boucherie
|
OF THE ROOM FOR DISTILLATION.We have hitherto considered the liquor as containing only principles upon which the air has no action, and from which it can only extract some watery vapors; and, in fact, all those principles contained in the liquor are fixed. The action of the fire may concentrate, but not volatilize them. The liquor is now changed by the fermentation; it contains no longer the same principles, but has acquired those which it had not, which are volatile, and evaporate easily. They must therefore be managed carefully, in order not to lose the fruits of an already tedious labor. The spirit already created in the fermented liquor, must be collected by the distillation; but in transporting it to the still, the action of the external air must be carefully avoided, as it would cause the evaporation of some of the spirit. A pump to empty the hogsheads, and covered pipes to conduct the liquor into the still, is what has been found to answer that purpose. A good distilling apparatus is undoubtedly the most important part of a distillery. It must unite solidity, perfection in its joints, economy of fuel, rapidity of distillation, to the faculty of concentrating the spirit. Such are the ends I have proposed to myself in the following apparatus. The usual shape of stills is defective; they are too deep, and do not present enough of surface for their contents. They require a violent fire to bring them to ebullition; the liquor at bottom burns before it is warm at the top. My still is made upon different principles, and composed of two pieces, viz. the kettle, and its lid. The kettle, forming a long square, is like the kettle of infusion, already described, and only differs from it in being one foot deeper. The lid is in shape like an ancient bed tester; that is to say, its four corners rise into a sharp angle, and come to support a circle 16 inches diameter, bearing a vertical collar of about two inches. This collar comes to the middle of the kettle, and is elevated about 4 feet from the bottom. The lid is fastened to the kettle. The collar receives a pewter cap, to which is joined a pipe of the same metal, the diameter of which decreases progressively to a little less than 3 inches: this pipe, the direction of which is almost horizontal, is 5 feet long. My still, thus constructed, is established upon a furnace like that of the infusion room. I observe that the side walls are only raised to the half of the height of the kettle. A vertical pipe is placed on the side opposite to the pewter one, and serves to fill up the still: it is almost at the height of the fastening of the lid, but a little above. On the same side, on a level with the bottom, is a pipe of discharge, passing across the furnace: this pipe must project enough to help to receive or to direct the fluid residue of the distillation; its diameter must be such as to operate a prompt discharge of the still. |
